Oiling is a necessary supplement for the moving parts to run smoothly, more importantly, to stay sharp. ![]() Turn the clipper on and let it run for about two minutes. Once you're done, add oil to the middle and corner of each blade's teeth. Now, compile the blades on the clipper head and screw them tightly. Remember to tick the inner part of the blade with a marker.Ĭlean the debris off the blade with a dry rag after sharpening. Repeat this three to four times to give it a lustrous shine.īesides, you should see a similar result once you rub off the highlighted part of the blade. Scrub on for about 30 seconds and start over with a new piece of sandpaper. Scrub the interior of the blades over the sandpaper. Spray the sandpaper with some oil or water for fluid motion. When you think you've done a good job, switch over to the 8000 grit side of the whetstone and repeat the process. You can use a fast motion or make long scenic strides over the stone. Press the blade flat on the whetstone, then glide it back and forth over the length of the stone. Lubricate the stone with a dash of water or clipper oil over the area you want to work. Place the whetstone on a flat surface with the 3000 grit side facing up.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |